Polaris Unibridge - Gray # 5825

Creates a surface for pool cleaners to travel over. The Unibridge fits over most raised suction outlet covers creating a surface for pool cleaners to travel over without obstruction.

The Polaris Unibridge prevents pool cleaners from getting caught on properly installed anti-vortex suction outlet (main drain) covers.
1. Attach the three flexible leaves by pushing the plugs completely through their corresponding holes.
2. Lay the centerpiece upside-down on a flat surface. Align the screw holes on the leaves to those on the centerpiece, and push into place.
3. Install the nine self-tapping screws (taped to the underside of the centerpiece) and tighten until snug. Do not overtighten.
4. Drop the assembled Unibridge upside down into the pool and let it sink to the bottom. Using a telepole (with net/brush attached), maneuver the Unibridge into position and then flip it over the antivortex main drain cover.


Warning: Unibridge is NOT a suction outlet (drain) cover, nor is it permanently installed. Unibridge is NOT intended to be a suction outlet cover. Further more, it is NOT intended to take the place of (or replace) a properly and permanently installed suction outlet over which is compliant with the Virginia Graeme Baker (VGB Pool & Spa Safety Act and with ASME/ANSI A112.19.8 (2007 or later).

Unibridge MUST ONLY be used with a properly installed, VGB-compliant suction outlet cover.